- A fat quarter (I used 2 scraps of different cotton fabrics)
- Embroidery Thread
- Skin coloured jersey scrap
- Paper and a Pen
Ability requirements: These instructions are for a very basic doll that can be completely hand stitched or machine stitched. This version is not suitable for very small children as it doesn’t have the reinforcements to make sure it can withstand a good chew/ tugging match. I have also minimally used any technical information (like right/ wrong sides of fabric, fabric bias touching, grain, hidden stiches etc) as I wanted to make it accessable to anyone. When I did use a technical term I tried to provide a link. If you know enough to know about these terms, you would also know when they are implimented.
Step 1: Place your the palm of your hand on the sheet of paper and loosely use it as a size guide to make a half oval shape
Step 2: Add a 1/4 inch seam allowence to the outside of your half oval.
Step 3: Place your thumb in the very centre of the straight edge of the oval. Mark either side. This is going to be your neck hole.
Step 4: Fold your fabric in half. Line the straight edge of the oval up against the fold in the fabric. Cut both layers of the fabric around the round part of the pattern only. If you open it up after cutting, you should have a long oval.
Step 6: Fold your material like you did for the body. Place the edge of the triangle onto the fold. Cut around the hat except for the folded edge.
Step 7: Turn your hat inside out so the coloured parts are touching. Sew a straight seam up the long angle. Fold a bit of the open edge over and iron. See photo below. Please note: I have used a surger for the angle seam but you don’t need to. You can do this by hand using a straight stitch.
Step 8: You do the same thing again with the body of the angel. Put the pattern sides together. Sew a 1/4 inch seam around the round part of the body. Then you need to cut a little opening for the neck. Your pattern will have the marks on it which you can use as a guide. Just a little bit wider than your thumb.
Step 9: Turn the body right side around by pulling the fabric through the hole. Then stuff it with your stuffing.
Step 13: Tie a piece of embroidery floss 3/4 of the way down the ball.
Step 14: Take hat, turn inside out so that the colored side is facing out and tie it onto the head of the angel. Sew the hat onto the head. I use a ladder stitch.
Step 15: Place head into body. Sew around the neck attaching the body fabric to the head.
Step 16: Tie off securely and enjoy!
Written by Rachel from Oast. A Waldorf doll maker from Canada living in the rolling hills of the English countryside with her daughter, her gestating son and her awesome husband.